Ford Mustang

it’s mE~! asked:


How do I remove the original stereo unit in a 2002 Ford Mustang GT? What information can you tell me about replacing it? Thanks!

Craig

ruben218 asked:


My roof on my 2000 Ford mustang is starting to tear from the rear window area. How do i install a new roof? does anyone know the steps to installing the convertible top? do i need a roof with a window? or can i just buy the meterial, and use the same window?

Reginald

thug_79901 asked:


I have a 1998 ford mustang 3.8L and I was wondering which dual exhaust system to buy. I’ve looked at several brands but I haven’t bought it yet. I’m looking for a better sound and better horsepower.

Vera

Cardinal killa fo life asked:


I have a 1994 ford mustang and the sounds system is descent but i would like to make it sound better. What should i buy that i could put in it to make it sound better. thanks

Megan

monstermott2002 asked:


just bought the 89 ford mustang and i am planning to make some modifications to make it a street/strip car. I have heard that when racing your car at a drag strip it is a must to have a fuel pressure gauge so then when ur pressure drops you notice and get out of it. So, how hard is it to put a fuel pressure gauge on. Also i am an unskilled person with a will to learn so should i do this myself or take it in?

Rhonda

Sabra C asked:


How do I find a 3.8 v-6 motor for a 1986 Ford Mustang with a automatic transmission?

Clinton

Peter Piper asked:


I am considering buying a used 2005 Ford Mustang stock GT and supercharging it. The best supercharger for the Mustang GT appears to be a Whipple twin Screw type that produces about 6 psi of boost, and as a result improves HP at the rear wheels to about 405, which is is pretty dramatic. However, this Whipple setup does NOT come with an intercooler. My question is, is it “safe” to bolt on this much power without an intercooler??? Thanks for your answers.

Greg

nak asked:


I have a 2000 Ford Mustang and i have a rod knocking and piston slap and i need to rebuild the engine. I am well versed in older pre-1990 technology and i’m wondering what kind of tricky areas/troubles am i looking at, can the engine be taken out from the top or from under the car. Any special tools required. Any suggestions or help would be greatly appreciated. Thanks for your time.

Gail

spudmustang asked:


I’m restoring a 1965 Ford Mustang. I’ve stripped it down to a rolling chassis, and in the process discovered that the floor panels are rusted through in several places. I’ve also discovered evidence that the car had been in a front-end collision. I wanted to do a lot of the body work myself, but now I’m worried that cutting out the entire floor will cause the chassis to bend. I’m also worried that the chassis may already distorted due to the collision. How do I replace the floor without warping the chassis, and how can I be sure that the chassis is straight?

Pearl

summer lovex3 asked:


I’m looking for a nice used car and I found a 2001 Ford Mustang Coupe in my area that is in my price range. One problem - its mileage. I want to know what range is a good mileage. So my question is what is considered good mileage for this car?

Thanks for you help.

Dolores